Calle

Calle

15
Followers
12
Following
Calle
More ideas from Calle
661 gilla-markeringar, 18 kommentarer - Stephan Schmitz (@adortable) på Instagram: "I built this coffee-table because I like the combination of old wood and concrete. . . Diesen…"

661 gilla-markeringar, 18 kommentarer - Stephan Schmitz (@adortable) på Instagram: "I built this coffee-table because I like the combination of old wood and concrete. . . Diesen…"

549 Likes, 32 Comments - Josh Freeman (@lolometalsmith) on Instagram: “A quick little press tool to make some stainless hold downs for fuel/air lines! #freemanfabrication…”

549 Likes, 32 Comments - Josh Freeman (@lolometalsmith) on Instagram: “A quick little press tool to make some stainless hold downs for fuel/air lines! #freemanfabrication…”

6 трюков для домашнего мастера #45 | я сам | Яндекс Дзен

6 трюков для домашнего мастера #45 | я сам | Яндекс Дзен

Here Is One Neat Metalshaping Trick You Should Learn.

Here Is One Neat Metalshaping Trick You Should Learn.

Tool post dial indicator holder

After seeing Paul Jones tool post dial indicator holder I had to have something like that. I have the same issue as Paul, no flat spot to easily mount

Tailstock Alignment. by tonyfoale - There are two usual methods to align a lathe tailstock.1. Put a bar between centres and take a cut along its length, measure each end, adjust tailstock and repeat procedure until it is within acceptable limits. This is time consuming and you reduce your bar to swarf.2. Get a standard ground alignment bar made for the purpose. Mount it and traverse its length with an indicator. Adjust tailstock to suit. This can be much quicker than method 1. but you nee

There are two usual methods to align a lathe tailstock. Put a bar between centres and take a cut along its length, measure each end, adjust